If you’re trying to replace natural grass or add a fresh layer of beauty and relaxation to your balcony, patio or lawn, installing artificial grass is a straightforward procedure.
To begin, prepare the base by flattening any dirt and eliminating any vegetation. To create an even surface for your turf then add a layer sand on the base and a geotextile membrane.
Laying the grass
When you lay artificial grass it is essential to lay it correctly. This includes removing weeds, grass in preparation, and then installing the turf.
Spray the area with a broadspectrum insecticide prior to when you start laying artificial grass. This can take two to four weeks, but it will make the job much easier once you start installing the sod.
You run the risk of getting drainage issues or weed issues if you don’t get rid of the old grass and weeds. These could cause problems when you attempt to complete the installation. It is important to take care before installing the sod.
Once you’re ready to lay the sod over the surface lay out the artificial turf. It is best to lay the sod in a directional direction that is, the blades must bend towards your home and not stand straight up.
Joining the Grass
If you want your artificial grass to look as good as it can it should be cut and finished properly. This involves taking away the old surface and putting infill.
The preparation of your garden for new grass requires you to get rid of all weeds and stones and ensure that it is strong enough to support the turf. This will require some compaction, but it is important for drainage.
After the base is ready and your grass is laid flat, roll it out. Fold the grass 30-40cm from each end. Trim 20-30mm from each edge.
It is an excellent rule of thumb to cut in by at least 3 tufts.
Now that you have two pieces of artificial grass running parallel to one another Join them with joint tape that is shiny-side up along the entire length. Attach the tape at either end using nails or adhesive.
Trimming the Grass
The trimming of the lawn is a crucial step regardless of whether you’re installing artificial grass for the first time or planning for the big landscaping project. This will ensure that your lawn looks great and is well-maintained.
You can trim your turf in two ways in which you can trim it vertically (called “edging”) and horizontally (called “trimming”). You can trim your turf along the edges of driveways, patios and bed spaces.
Avoid cutting the turf so short that weeds may penetrate the soil. The turf that touches the ground can encourage seeds to germinate and grow more quickly.
Using a razor blade, cut the turf as evenly as possible while making sure not to leave any gaps or wrinkles. To ensure smooth and consistent cuts work slowly and with care.
Finalizing the Grass
The final step of installing artificial grass is to finish the base layer and fixing the turf to the ground. This is an important part of the process that should be done with the proper maintenance.
Rake the area to level it and then rake away any large rocks or high spots. This is especially important if you are installing on a sloped area.
For a better finish, make sure to brush the turf blades to smoothen the infill layer. This helps to ensure that the turf appears natural and is flat, without bumps.
Then, spread the grass out on the base, making sure that all adjacent sheets are facing the same way. This is essential to maintain the appearance of the grass and also to prevent grass from ripping in other directions.
Make relief cuts in the event that there are trees or other objects in the area, to allow the synthetic turf to be able to bend around them. These should touch the base of the obstruction or tree and then run from the bottom to the top.
