Whether you’re seeking to replace natural grass or add a new level of beauty and ease to your balcony, patio or lawn installing artificial grass is an easy procedure.
First prepare the base by eliminating all vegetation and dirt. To create a level surface for your turf, add a layer of sand to the base and a geotextile membrane.
Laying the Grass
It is important to properly lay artificial grass when installing it. This includes removing the grass and weeds that are already there, preparing the ground, and installing the turf.
Before you lay the artificial grass apply a broadspectrum herbicide to kill the existing vegetation (grass and weeds) in the space. It could take up to four weeks for this process but it will make your job simpler once you start in laying the sod.
You run the risk of having drainage issues or weed problems if you do not get rid of the old grass and weeds. These issues can cause problems when you try to finish the installation. It’s important to take care before putting in the sod.
When you’re ready to lay the sod on the surface and roll out the artificial turf. It’s best to place it in a direction with directionally, meaning that the blades incline towards your home instead of standing straight up.
Joining the Grass
If you want your artificial grass to look as beautiful as it can be, it needs to be cut and finished properly. This requires taking away the old surface and then filling it with a new one.
To prepare your base for the grass to grow, you must remove all weeds and rocks from the surface and make sure it is level enough to allow the turf to be supported. This will require a good amount of compaction, but it is worth the effort for an efficient drainage.
Once the base is prepared Once you have your grass laid out, roll it flat. Fold the grass down 30-40cm at each end. Cut off 20-30mm from each edge.
It is an excellent rule of thumb to cut it in by at most 3 tufts.
If you have two pieces of artificial grass that run parallel to one another Join them with joint tape with shiny sides along their entire length. Secure the tape at one end with nails or adhesive.
Trimming the Grass
Cutting the lawn is a must when you’re installing artificial grass for the first time or planning the big landscaping project. This will ensure that your lawn is even and looks stunning!
You can trim your turf in two ways either vertically (called “edging”) and horizontally (called “trimming”). Edging is carried out around the borders of driveways, bed spaces and patios.
When you’re trimming the turf, try to avoid cutting it so much that weeds can get into the soil. Having the turf touch the ground allows weeds to germinate quickly and grow faster.
Using a razor blade, cut the turf as evenly as possible, making sure not to leave any gaps or wrinkles. Make sure to work slowly and with care to ensure that the cuts are smooth and uniform.
Finishing the Grass
The final step to install artificial grass is finishing the base layer before securing the turf to the ground. This is a crucial aspect of the process that should be done with care. maintenance.
Get rid of any large rocks or high points. This is particularly important if you are installing on a sloped surface.
For a better finish, make sure to brush the turf blades to smooth the infill layer. This ensures that the turf appears natural and has a flat surface without bumps.
Then, roll the grass over the base. Make sure all sheets are facing the same direction. This is crucial for good appearance and stops grass from cutting in different directions.
Cut relief cuts if there are trees or other obstructions in the area, to allow the synthetic turf to bend around them. They should be able to touch the base of the tree or obstruction and continue upwards.
